A flat roof coating restores your roof with a seamless membrane. It repairs leaks by sealing cracks and seams. Applying an elastomeric coating is a cost-effective way to preserve your metal roof without the cost and disruption of tearing off an existing roof and replacing it.
Elastomeric coatings are fluid-applied roofing membranes with elastic properties that allow it to expand and contract with the substrate.
Elongation in roof coatings typically ranges from 300 - 800%. Without good elongation, a roof coating is no longer considered an elastomeric.
As the membrane thickness goes up, elongation increases while tensile strength decreases. Elongation is important because roofs tend to expand and contract to allow the coating to move with the substrate and not crack or peel off.
ASTM D6083 requires a dry film thickness of 20 dry mils for testing.
Proper film thickness is essential to achieve the desired performance in elastomeric roof coatings. In general, elastomeric roof coatings should be applied at a minimum of 20 mils dry film thickness (DFT) to meet the physical properties in the technical data sheet.
Correct film thickness is key to effectively protecting the substrate from UV degradation. A thin coat will not have enough UV blocking and crack bridging capability. This is the reason why we tint our primers to a dark color. A dark surface will show through the coating and make a white coating look gray.
Oftentimes, contractors will sell a 2-coat system but fail to specify the total dry film thickness of the installed membrane. If in doubt, please ask us for details and clarification. They should strive to put down at least 30 dry mils to ensure they are getting at least 25 dry mils on any thin areas.
Elastomeric coatings sold in home improvement stores that are intended for masonry, stucco, or brick are not designed for roofing applications. Be sure you have the right product!
Water-based, acrylic elastomeric roof coatings are widely used over metal and spray foam roofs by contractors and building owners performing DIY restorations. They are best used on roofs that don’t have ponding water.
Solvent-based elastomeric coatings have higher ponding water resistance and is more suitable for low slope or flat roofs. Solvent-based roof coatings have much better ponding water resistance than acrylic roof coatings.
Airless spray equipment provide quick application with even coverage over uneven areas and roofs with a lot of penetrations or HVAC units. They are available in several models and can be customizable for each coating which eliminates the need to purchase additional rigs. Acrylic coatings can use a roof rig with a 2,000 psi pressure, 1.5 gpm spray rate and a 631 spray tip. Silicone coatings requires a larger rig with higher pressure and a 4.0 gpm spray rate.
Roof coating spreaders offer low cost, even coverage and quicker clean up than other application methods. With roller widths up to 40", they can cover 1200SF a minute. Special profile rollers for metal roofs. Spreaders are especially useful on projects where overspray is a concern.
Foam rollers can be used over flat roofs when applying primers. Long nap rollers are recommended for base coats and finish coats. Roof rigs can also be fitted with a power roller attachment to speed up the process.