EnergyMax Acrylic Coating

Product Description

EnergyMax Acrylic Coating is an ASTM D-6083 compliant roof coating. Easy water clean up.


It can be used to stop roof leaks and extend the service life of metal and spray foam roofs.


  • Meets or exceed ASTM D-6083.
  • Provides a seamless, elastic and durable membrane.
  • Contains fungicides and mildewcides.
  • Superior adhesion to various substrates.
  • Reflective roof coating helps reduce cooling costs, prevents UV-degradation and premature roof failure.
  • Easy to use, non-toxic and VOC-compliant water based roof coating.


  • Ready to use. Thinning is not necessary. 
  • Mix well before using.Do not use on ponding water locations.
  • Roof must be clean, dry and free of any oil, grease, dirt or loosely adhered coating. Bare surfaces must be prepared and checked for compatibility.
  • Follow our roof restoration procedures and always perform an adhesion test.
  • Equipment: polyester brush, long nap roller, spreader or 3000psi, 2gpm airless sprayer with a .031 tip.
  • Do not leave coating in spray guns, hoses and pumps for prolonged periods.
Could not load Commerce. Please try again later.

Caution: This product is water-based product which will freeze and become unusable at temperatures below 32°F. Suspend all application if conditions prevent a complete cure before sunset, rain, fog, dew or freezing temperatures. Lexis Coatings must be completely dry before exposing to water or foot traffic. Keep Lexis Coatings containers covered when not in use. Dispose of all containers in accordance with state and local environmental regulations. Keep away from children. If ingested, DO NOT induce vomiting. Call physician immediately.

Product information contained herein are presented in good faith and believed to be reliable. They do not constitute part of our terms and conditions of sale. It is also not a guarantee, either expressed or implied, that the data are correct or that products described are merchantable or fit for a particular purpose as methods of use are beyond our control. Customer should determine the suitability of our materials and installation recommendations before usage. Manufacturer’s sole responsibility shall be to replace that portion of any product that proved to be defective.

EnergyMax Acrylic Coating

Technical Data

Property Value Test Method
Clean UpSoap & Water
Coverage1gal/100SF yields 9.6 dry mils.
Up to 1.5gal/100SF per coat.
2 coats, 25-30 dry mils recommended.
Density12.1 ± 0.2 pound/gallon
Dry TimeDry to touch: 4 - 6 hours @ 75°F.
Tack Free: 12 hours
12 - 24 hours to recoat.
Depending on humidity and moisture.
Elongation239%ASTM D-2370
Emittance0.88ASTM C-1371
Flash PointNone
Hardness45 Shore AASTM D-2240
Impact Resistanceexceeds 160b in/lb
Packaging5 gallon pail, 55 gallon drum
Permeability6.5 permsASTM D1653
Reflectance86% | 66% @ 3 YearsASTM C-1549
Salt SprayNo effect(3800 hours)
Shelf Life12 months @ 45°F-80°F
Service Temperature-40°F to 200°F
Solids by Volume53% ±3%ASTM D-2697
Solids by Weight65% ±2%ASTM D-1644
Tensile Strength278 psiASTM D-2370
Viscosity10,000 ± 3,000 cps, 94KUASTM D-562