EnergyGuard Acrylic Clear


EnergyGuard Acrylic Clear Coat is a water-based, single component, clear acrylic roof coating. 


It is designed to restore and protect fiberglass skylights or improve the dirt pick up resistance of our white acrylic roof coatings.


  • Provides a seamless, elastic and durable membrane.
  • Extends the life of fiberglass skylights.
  • Superior adhesion to brick, stucco and masonry surfaces.
  • Enhances dirt pickup resistance when used over elastomeric roof coatings.
  • Easy to use, non-toxic and VOC-compliant.


  • Ready to use. Thinning is not necessary. Mix well before using.
  • Do not use on ponding water locations.Roof must be clean, dry and free of any oil, grease, dirt or loosely adhered coating. 
  • Bare surfaces must be prepared and checked for compatibility.
  • Follow our roof restoration procedures and always perform an adhesion test.
  • Equipment: polyester brush, long nap roller, spreader or 3000psi, 2gpm airless sprayer with a .017 tip.
  • Do not leave coating in spray guns, hoses and pumps for prolonged periods.
Could not load Commerce. Please try again later.

Caution: This product is water-based product which will freeze and become unusable at temperatures below 32°F. Suspend all application if conditions prevent a complete cure before sunset, rain, fog, dew or freezing temperatures. Lexis Coatings must be completely dry before exposing to water or foot traffic. Keep Lexis Coatings containers covered when not in use. Dispose of all containers in accordance with state and local environmental regulations. Keep away from children. If ingested, DO NOT induce vomiting. Call physician immediately.

Product information contained herein are presented in good faith and believed to be reliable. They do not constitute part of our terms and conditions of sale. It is also not a guarantee, either expressed or implied, that the data are correct or that products described are merchantable or fit for a particular purpose as methods of use are beyond our control. Customer should determine the suitability of our materials and installation recommendations before usage. Manufacturer’s sole responsibility shall be to replace that portion of any product that proved to be defective.

EnergyGuard Acrylic Clear

Technical Data

Property Value Test Method
Clean UpWater
ColorClear (Translucent)
Coverage0.4/100SF - 0.6/100SF depending on surface porosity.
Density8.7 lbs/gal ± 0.2
Flash PointNone
Hardness60 Shore A
Shelf Life12 months @ 40°F-90°F
Solids by Volume40%
Solids by Weight43.5%
Tensile Strength1400 psi
Viscosity2,000 ±500 cP
VOC<50 grams/liter