PrimeLock EPDM Primer SDS

Safety Data Sheet

I. IDENTIFICATION

PRODUCT IDENTIFICATION
  • PrimeLock EPDM Primer
  • Packaging:
  • CAS Number: 
  • Date Updated: Thursday, May 10, 2018
  • EMERGENCY TELEPHONE NUMBER: ChemTrec: (800) 424-9300
SUPPLIER INFORMATION

II. HAZARDS(S) IDENTIFICATION

Hazard Pictograms
  • Corrosive
    Corrosive
  • Skin Corr. 1B H314 Causes severe skin burns and eye damage.
  • Eye Dam. 1 H318 Causes serious eye damage.
  • Hazard-determining components of labeling: disodium metasilicate
  • Hazard statements:  Causes severe skin burns and eye damage.
  • Precautionary statements
  • Do not breathe dusts or mists.
  • Wear eye protection / face protection.
  • Wash thoroughly after handling.
  • If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower.
  • If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do.
  • Continue rinsing.
  • Immediately call a POISON CENTER/doctor.
  • Specific treatment (see on this label).
  • IF INHALED: Remove person to fresh air and keep comfortable for breathing.
  • Wash contaminated clothing before reuse.
  • If swallowed: Rinse mouth. Do NOT induce vomiting.
  • Store locked up.
  • Dispose of contents/container in accordance with local/regional/national/international regulations
  • Classification system:
  • NFPA ratings (scale 0 - 4)
  • Health = 3  Fire = 00 Reactivity = 0
  • HMIS-ratings (scale 0 - 4)
  • Health = 3   Fire = 0 .  Reactivity = 0
  • Other hazards
  • Results of PBT and vPvB assessment
  • PBT: Not applicable.
  • vPvB: Not applicable.

III. COMPOSITION / INFORMATION ON INGREDIENTS

  • Chemical characterization: Mixtures
  • Description: Mixture of the substances listed below with nonhazardous additions.
Dangerous components:
6834-92-0disodium metasilicateSkin Corr. 1B, H314; STOT SE 3, H3353-7%
Anionic, Nonionic SurfactantAcute Tox. 4, H3020.5-1.5%
Non-Hazardous Components
7732-18-5
water, distilled, conductivity or of similar purity60-100%

IV. FIRST-AID MEASURES

  • Description of first aid measures
  •  General information:
  • First Aid responders should pay attention to self-protection and use the recommended protective clothing. If potential for exposure exists refer to Section 8 for specific personal protective equipment.
  • After inhalation: Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if symptoms persist.In case of unconsciousness place patient stably in side position for transportation.
  • After skin contact: Immediately wash with water and soap and rinse thoroughly. Get medical attention if symptoms occur. Suitable emergency safety shower should be immediately available.
  • After eye contact: Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.
  • After swallowing: Do not induce vomiting; immediately call for medical help.Do not induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person.
  • Information for doctor: Treatment of exposure should be directed at the control of symptoms and the clinical condition of the patient.
  • Most important symptoms and effects, both acute and delayed. No further relevant information available.
  • Indication of any immediate medical attention and special treatment needed. No further relevant information available.

V. FIRE-FIGHTING MEASURES

  • Extinguishing media
  • Suitable extinguishing agents: CO2, extinguishing powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
  • Special hazards arising from the substance or mixture No further relevant information available.
  • Advice for firefighters
  • Protective equipment:
  • Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus (SCBA) with a full face-piece operated in positive pressure mode. PVC boots, gloves, safety helmet and protective clothing should be worn.

VI. ACCIDENTAL RELEASE MEASURES

  • Personal precautions, protective equipment and emergency procedures
  • Isolate area. Keep unnecessary and unprotected personnel from entering the area. Spilled material may cause slipping hazard. Refer to Section 7, Handling, for additional precautionary measures. Use appropriate safety equipment. For additional information, refer to Section 8, Exposure Controls and Personal Protection.
  • Environmental precautions: Do not allow to enter sewers/ surface or ground water.
  • Methods and material for containment and cleaning up: Ensure adequate ventilation.
  • Reference to other sections
  • See Section 7 for information on safe handling.
  • See Section 8 for information on personal protection equipment.
  • See Section 13 for disposal information.

VII. HANDLING AND STORAGE

  • Handling:
  • Precautions for safe handling.  Ensure good ventilation/exhaustion at the workplace.
  • Information about protection against explosions and fires: No special measures required.
  • Conditions for safe storage, including any incompatibilities
  • Storage:
  • Requirements to be met by storerooms and receptacles: No special requirements.
  • Information about storage in one common storage facility: Not required.
  • Further information about storage conditions: Keep receptacle tightly sealed. Storage Period: 12 months Storage Temp: 15 -35°C
  • Specific end use(s): No further relevant information available.

VIII. EXPOSURE CONTROLS / PERSONAL PROTECTION

  • Control parameters
  • Components with limit values that require monitoring at the workplace:The product does not contain any relevant quantities of materials with critical values that have to be monitored at the workplace.
  • Additional information: The lists that were valid during the creation were used as basis.
  • Exposure controls
  • Personal protective equipment:
  • General protective and hygienic measures: Keep away from foodstuffs, beverages and feed. Immediately remove all soiled and contaminated clothing. Wash hands before breaks and at the end of work.Avoid contact with the eyes and skin.
  • Breathing equipment: In case of brief exposure at low atmospheric levels use an approved air-purifying respiratory equiped with an organic vapor sorbent and a particle filter. In case of intensive or longer exposure use a positive pressure air- supplying respirator (air line or self-contained breathing apparatus).
  • Protection of hands: Protective gloves. The workplace factors such as, but not limited to: Other chemicals which may be handled, physical requirements (cut/puncture protection, dexterity, thermal protection), potential body reactions to glove materials, as well as the instructions/specifications provided by the glove supplier.
  • Material of gloves: Use chemical resistant gloves classified under Standard EN374: Protective gloves against chemicals and micro- organisms. Examples of preferred glove barrier materials include: Butyl rubber, Polyethylene, EVAL, Neoprene, Nitrile, Viton. When prolonged or frequently repeated contact may occur, a glove with a protection class of 5 or higher is recommended.
  • Penetration time of glove material: The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
  • Eye protection: Tightly sealed chemical goggles consistent with EN 166 or equivalent. Wear a face-shield which allows use of chemical goggles, or wear full-face respirator to protect face and eyes when there is any likelyhood of splashes.
  • Body protection: Personal protective clothing for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product.

IX. PHYSICAL AND CHEMICAL PROPERTIES

  • Information on basic physical and chemical properties
  • General Information
Appearance
FormLiquid
ColorPink
OdorSweetish
Odor thresholdNot determined
ph valueNot determined
Change in condition
Melting point/Melting rangeUndetermined
Boiling point/Boiling rangeUndetermined
Flash PointNot applicable
Flammability (solid, gaseous)Not applicable
Ignition temperature
Decomposition temperatureNot determined
Auto ignitingProduct is not selfigniting
Danger of explosionProduct does not present an explosion hazard
Explosion limits
Lower:Not determined
Upper:Not determined
Vapor pressureNot determined
DensityNot determined
Relative densityNot determined
Vapor densityNot determined
Evaporation rateNot determined
Solubility in / Miscibiligy with
WaterNot miscible or difficult to mix
Partition coefficient (n-octanol/water)Not determined
Viscosity
DynamicNot determined
KinematicNot determined
Other InformatonNot further relevant information available

X. STABILITY AND REACTIVITY

  • Reactivity No further relevant information available.
  • Chemical stability: This product is stable at recommended storage conditions (See Section 7).
  • Thermal decomposition / conditions to be avoided: No decomposition if used according to specifications.
  • Possibility of hazardous reactions: No dangerous reactions known.
  • Conditions to avoid: No further relevant information available.
  • Incompatible materials: No further relevant information available. 
  • Hazardous decomposition products: No dangerous decomposition products known. 

XI. TOXICOLOGICAL INFORMATION

  • Information on toxicological effects
  • Acute toxicity:
  • LD/LC50 values that are relevant for classification:
  • 6834-92-0 disodium metasilicate
  • OralLD501280 mg/kg (rat)
  • Primary irritant effect:
  • on the skin
  • Irritant to skin and mucous membranes.
  • Irritating effect.
  • on the eye: Irritating effect.
  • Sensitization: No sensitizing effects known.
  • Additional toxicological information:
  • The product shows the following dangers according to internally approved calculation methods for preparations: Irritant
  • Carcinogenic categories
  • IARC (International Agency for Research on Cancer): None of the ingredients is listed.
  • TP (National Toxicology Program): None of the ingredients is listed.
  • OSHA-Ca (Occupational Safety & Health Administration)

XII. ECOLOGICAL INFORMATION

  • Toxicity
  • Aquatic toxicity: No further relevant information available.
  • Persistence and degradability: No further relevant information available.
  • Behavior in environmental systems:
  • Bioaccumulative potential: No further relevant information available.
  • Mobility in soil: No further relevant information available.
  • Additional ecological information:
  • General notes: Water hazard class 1 (Self-assessment): slightly hazardous for waterDo not allow undiluted product or large quantities of it to reach ground water, water course or sewage system.
  • Results of PBT and vPvB assessment
  • PBT: Not applicable.
  • vPvB: Not applicable.
  • Other adverse effects: No further relevant information available.

XIII. DISPOSAL CONSIDERATIONS

  • Waste treatment methods
  • Recommendation:The generation of waste should be avoided or minimized wherever possible. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe way. Dispose of surplus and non-recyclable products via a licensed waste disposal contractor. Disposal of this product, solutions and any by-products should at all times comply with the requirements of environmental protection and waste disposal legislation and any regional local authority requirements. Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers.
  • Uncleaned packagings:
  • Recommendation: Disposal must be made according to official regulations.

XIV. TRANSPORT INFORMATION

UN-Number
- DOT, IMDG, IATAUN1719
UN proper shipping name
- DOTCaustic alkali liquids, n.o.s.
- IMDG, IATACAUSTIC ALKALI LIQUID, N.O.S.
Transport hazard class(es)
- DOT, IMDG, IATA
- Class8 Corrosive substances
Packing group
- DOT, IMDG, IATAIII
Environmental hazards:
- Marine pollutant:No
Special precautions for userWarning: Corrosive substances
EMS Number:F-A,S-B
Segregation groupsAlkalis
Transport in bulk according to Annex II of MARPOL73/78 and the IBC CodeNot applicable.
UN "Model Regulation":UN1719, Caustic alkali liquids, n.o.s., 8, III

XV. REGULATORY INFORMATION

  • Safety, health and environmental regulations/legislation specific for the substance or mixture
  • Clean Air Act: None of the ingredients is listed
  • Clean Water Act: None of the ingredients is listed.
  • Sara
  • SARA 302/304 Extremely Hazardous Substance: None of the ingredients is listed.
  • Section 355 (extremely hazardous substances): None of the ingredients is listed.
  • Section 313 (Specific toxic chemical listings): Non e of the ingredients is listed.
  • TSCA (Toxic Substances Control Act): All ingredients are listed.
  • Proposition 65
  • Chemicals known to cause cancer: None of the ingredients is listed.
  • Chemicals known to cause reproductive toxicity for females: None of the ingredients is listed.
  • Chemicals known to cause reproductive toxicity for males: None of the ingredients is listed.
  • Chemicals known to cause developmental toxicity: None of the ingredients is listed.
  • Carcinogenic categories
  • EPA (Environmental Protection Agency)None of the ingredients is listed.
  • TLV (Threshold Limit Value established by ACGIH)None of the ingredients is listed.
  • NIOSH-Ca (National Institute for Occupational Safety and Health)
  • Signal word: Danger
  • Hazard-determining components of labeling: disodium metasilicate
  • Hazard statements: Causes severe skin burns and eye damage.
  • Precautionary statements: Do not breathe dusts or mists.Wear eye protection / face protection.Wash thoroughly after handling.If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower.If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER/doctor.Specific treatment (see on this label).IF INHALED: Remove person to fresh air and keep comfortable for breathing.Wash contaminated clothing before reuse.If swallowed: Rinse mouth. Do NOT induce vomiting.Store locked up.
  • Dispose of contents/container in accordance with local/regional/national/international regulations.
  • Chemical safety assessment: A Chemical Safety Assessment has not been carried out.

XVI. OTHER INFORMATION

The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text.